BRP Rubber SUB Mount Kit | 24-27 KTM 125-500 All Models

Description

BRP Rubber SUB Mount Kit | 24-27 KTM 125-500 All Models

The BRP Rubber SUB Mount Kit uses (8) Poly-Urethane bushings to isolate vibration and reduce rider fatigue by softening the harsh spike of hitting square edge rocks and obstacles. Our kit comes complete with two different durometer bushings to fine tune the amount of vibration dampening.

BRP Rubber SUB Mount Kit | 24-27 KTM 125-500 All Models includes:

• 1) BRP Rubber Mounted SUB Adapter (RSA-901616-1)
• 1) Scotts Frame Bracket  (FBD-6125)
• 2) Sets of Rubber Bushings (Red = Medium and Blue = Soft.)
• 2) Aluminum upper cones (BMI-97-1214)
• 2) Aluminum lower cones (BMI-97-1223)
• 1) Hour meter spacer (TCH-2023-1)
• 1) Low profile stem bolt (TCH-2015-2720)
• 2) M12x60 hex bolts
• 2) M12 thin flat washers
• 2) M12 Fuji lock nuts

We recommend using a Clean Speed Cable Guide to ensure proper cable routing.  

Designed to mount a Scotts stabilizer below the handlebar using your OEM cast or billet triple clamp. The BRP Rubber Mounted SUB adapter mounts to the existing rear bar mount holes and allows you to run in position 3 which is the most common and popular position.

SUB Mounting a stabilizer offers several benefits over a conventional “above bar” setup and is becoming a very popular setup for GP’s, motocross, off road, dual sport applications and riders of taller stature.

• Offers an approximately 1″ taller bar position
• Lower Bend Bars can compensate for additional height.
• SUB Mounting reduces the risk of bodily injury
• Stabilizer sits under bars and safe from potential damage from a crash.

BRP is an authorized Scotts Stabilizer Dealer and Service center with an extensive knowledge of stabilizer mounting applications. We have a complete line of stabilizer mounting applications and replacement parts.

SPECIAL NOTES:

• When running a stabilizer in the sub mount configuration, the stabilizer link arm will need to be in the reverse position “going under the body of the unit”.
• To reverse the link arm we recommend using a Scotts Link Arm Puller.
• This unit cannot be used with cycra center reach mount handguards.
  

And don’t forget to check us out on Facebook to keep up to date on all our new product releases!