Enduro Engineering Replacement Shark Fin

Description

Enduro Engineering Replacement Shark Fin

Fits any model of the Enduro Engineering Rear Brake Disc Guard

REAR DISC GUARD FIN REPLACEMENT INSTRUCTIONS

1. Remove the rear wheel from the bike.
2. Slide the caliper carrier off of the swing arm.
3. Using a 4mm allen wrench remove the 3 bolts on the disc guard fin. (can be done by removing the caliper or leaving it on.)
4. Pull off the old fin from the carrier.
5. Slide new fin in place of the old fin lining the three mounting holes up. Depending on the wear on the caliper carrier, you may need to use a dead blow mallet to get the fin all the way lined up with the holes.
6. Insert the new bolts into the three mounting holes.
7. Tighten using a 4mm allen wrench.
8. Reinstall the carrier back on the swingarm and reinstall the rear wheel.
9. Have fun and enjoy your next ride.